Bell RS7 Helmet 1310B, Snell SA-2025 / FIA

Based on the HP7 design and featuring a lightweight carbon fiberglass composite shell, the RS7 uses an innovative shell and shield design to improve acoustic comfort, aerodynamic performance, and energy absorbing capabilities. The sleek, modern design features an advanced ventilation system with 14 air-intake and extraction channels that can be used with or without air-intake (available separately). The RS7 double screen anti-fog (DSAF) visor and rubber gasket seal ensure air, water and dust will not enter in the eyeport.

• Helmet, RS7, Full Face, Snell SA2025, FIA Approved, Head and Neck Support Ready, Carbon Composite, Flat Black

Bell Helmet Size Chart

Fitting your Bell Helmet

Proper helmet fit is vital to the performance of a helmet during an impact. For maximum protection the helmet must fit properly with the chin strap securely fastened and provide adequate peripheral vision.

Measuring the head is only a starting point for the entire sizing procedure. Due to varying shapes, heads that are apparently the same size when measured by a tape may not necessarily fit the same size helmet.  A small metal tape measure or a cloth tape may be used to make your initial measurement. You can also use a string, which can then be laid against a measuring tape.

The circumference of the head should be measured at a point approximately one inch above the eyebrows in front, and at a point in the back of the head that results in the largest possible measurement. Take several measurements. The largest measurement is the one you want to try on first. If you use a balaclava or head sock, always measure and fit the helmet with it on. Use the Bell sizing chart to determine the size that best matches the head measurement.

Available Sizes

• 1310B46: 57 cm
• 1310B47: 58 cm
• 1310B48: 59 cm
• 1310B50: 60 cm
• 1310B51: 61 cm
• 1310B52: 61+ cm