We are Open for Business and Shipping Daily!

Bell Vador Helmet - White
Bell Vador Helmet - Black

Bell Vador Helmet

BEL1422001 (1 in stock)

Regular price $449.90 Sale

The Bell Vador helmet incorporates a blunt nose design and pivot style shield.  Designed primarily for use by drag racers, karters and dirt track racers, the Vador is Snell SA2015 certified.  

The Vador features a lightweight composite shell, comfortable interior fit and rear facing vents to prevent dust and dirt from entering the helmet. The Vador takes a 289 SRV (3 mm) shield with thumb tab on the driver's left side to allow for easy shield operation, SRV-1 visor system and new rubber eyeport gasket for improved visor seal. Each helmet comes with a clear shield and Bell visor strip as standard equipment.

The Vador also features Bell's redesigned face piece with recessed areas that allow for seamless radio integration and easy installation.

  • Multi-use helmet 
  • Pilot style shield
  • Set-up for use with a Head & Neck Restraint device
  • Lightweight composite shell 
  • Rear facing chin bar vents
  • Recessed face piece for seamless radio integration
  • New rubber visor eyeport seal
  • E-Max multi-density liner
  • 289 SRV 3mm Shield (SRV-1 Pivot System)
  • Comfortable standard interior
  • Provision to attach M6 hardware built in to helmet
  • Snell SA2015 certification

Size Chart

Bell Helmet Size Chart

Standard Size Hat Size Inches Centimeters
4XS 6 3/8 20 1/16 51
3XS 6 1/2 - 6 5/8 20 1/2 - 20 7/8 52-53
2XS 6 3/4 - 6 7/8 21 1/2 - 21 5/8 54-55
XS 7 22 56
S 7 1/8 22 3/8 57
M 7 1/4 - 7 3/8 22 3/4 - 23 1/4 58-59
L 7 1/2 23 5/8 60
XL 7 5/8 - 7 3/4 24 - 24 3/8 61-62
2XL 7 7/8 - 8 24 3/4 - 25 1/4 63-64
3XL 8 1/8 - 8 1/4 25 5/8 - 26 65-66
4XL 8 3/8 - 8 1/2 26 3/8 - 26 3/4 67-68

Fitting your Bell Helmet

Proper helmet fit is vital to the performance of a helmet during an impact. For maximum protection the helmet must fit properly with the chin strap securely fastened and provide adequate peripheral vision.

Measuring the head is only a starting point for the entire sizing procedure. Due to varying shapes, heads that are apparently the same size when measured by a tape may not necessarily fit the same size helmet.  A small metal tape measure or a cloth tape may be used to make your initial measurement. You can also use a string, which can then be laid against a measuring tape.

Helmet Measurement

The circumference of the head should be measured at a point approximately one inch above the eyebrows in front, and at a point in the back of the head that results in the largest possible measurement. Take several measurements. The largest measurement is the one you want to try on first. If you use a balaclava or head sock, always measure and fit the helmet with it on. Use the Bell sizing chart to determine the size that best matches the head measurement.